Since no provision has been made for a power take-off from the gearbox, the crane can only be powered by an electric pump unit (heavy duty battery and heavy duty alternator required).

Before fitting a loading crane, perform a load distribution calculation to check for compliance with the permitted axle load and the minimum front axle load.

It is not permitted for a loading crane to be mounted on series production vehicles without special approval from the factory.
If ordering a vehicle for equipping with a loading crane, we recommend using the additional battery (PR no.: 8FB).

The chassis must be equipped with a mounting frame for mounting the loading crane (see note regarding the mounting frame).

Important notes:

• Provide supporting means for operation

For more information about the conversion, refer to:

• Dimensions and weights (chap. 2.1)
• Chassis dimension drawings (chap. 2.4)
• Maximum dimensions (chap. 2.6)
• Standard attachment points for special bodies (chap. 2.7)
• Roof racks, perm. roof loads (chap. 3.1)
• Wings and wheel houses (chap. 3.2)
• Mounting of additional units (chap. 3.3)
• Raising the vehicle (chap. 3.7)
• Vehicle battery protection (chap. 3.8)
• Fitting power take-offs (chap. 3.9)
• Brake system (chap. 3.11)
• Electrical connection (chap. 3.15)
• Turn signals in vehicles with excess width (chap. 3.18)
• Side wall cut-outs, installation of windows (chap. 4.1)
• Roof cut-outs (chap. 4.2)
• General notes on modifying standard vehicles (chap. 4.5)
• Cut-outs in the rear cab wall (chap. 5.2)
• Drilling on the chassis frame (chap. 5.3)
• Welding on the chassis frame (chap. 5.4)
• Wheelbase extensions and overhang extension (chap. 5.5)